| Connections & Dimensions |
| All radiators are supplied with 1" left and right hand threaded tappings suitable for 1/2" B.S.P reducers (supplied). The radiator is manufactured with bottom, opposite end connections. Plug and vent supplied. |
|
|
| Operating Pressures |
Maximum opertating pressure is 12Bar for 2,3 & 4 column radiators.
Click below for larger image |
|
|
|
| Wall Brackets |
| There are two wall bracket kits supplied as standard with all radiators and the contents of each kit are shown below. These are sufficient to support the combined weight |
 |
| of the radiator and water content. However consideration should be given to the radiator location, site conditions & wall construction, to determine waht extra (if any) provisionsare to be made. Optional floor mounts are available. |
|
| Floor Mounts |
| Additional fixtures and fittings (Not Supplied) will be required to complete the installation of the wall brackets |
 |
| and floor mounts. The type of fixtures and fittings to be used will depend on the type of wall or floor construction. |
|
|
|
|
| Sections |
| Radiator sections are supplied assembled ready for installation. Each section has a nominal width of 46mm (+/- 2mm) |
 |
|
| Heat Output |
| The heat outputs figures quoted have been derived from tests and approvals to EN442. |
|
|
| Finish & Packaging |
| All radiators are finished in superior white gloss RAL 9010 and individually packaged, being wrapped in heat shrink polythene film and double layered cardboard to prevent against any damage and scratches in transit. |
|
| Guarantee |
| Each radiator is fully guaranteed for 5 years from the dtae of installation for any defects arising due to faulty materials or manufacture. |
|
|
Standard Steel Radiators
 |
Special Steel Radiators
|
| |
)
)
)
)
